Crochet Rose Pattern.

download now

Crochet Rose is a beginner crochet pattern for the two layers crochet flower. You can make it in one color or in two colors (here is an idea: the second layer made in green will be leaves). The finished flower is approximately 3 1/2 inches (9 cm) in diameter if you used recommended yarn and hook size. Make it smaller if you need so by switching to thinner yarn and smaller hook size.

Crochet Rose Flower makes a great applique or a hair accessory :)

Recommended yarn: medium weight or worsted weight (weight category #4). I used Red Heart Super Saver.

Recommended crochet hook: I9/5.5 mm or J10/6.00 mm

Stitches and abbreviations used: CH - chain, SC - single crochet, DC - double crochet, slip stitch.



The center of the flower:

(this center "holds" arcs for both layers)

CH 3, join in a ring with a slip stitch.

The first layer:
(the arcs of the first layer):

CH 3

SC in the ring. You just made one arc for the petal. (one arc is CH 2, SC in the ring].

CH 2 for the second arc

SC in the ring and another CH 2. Repeat [SC in the ring, CH 2] 4 more times.

Total should be 6 arcs for 6 petals. Finish with a slip stitch.

Petals of the first layer:

in the first arc: [SC, DC, DC, DC, SC]

Repeat [ ] for 5 remaining arcs. Finish with a slip stitch in the back side of the flower.



The first layer is ready :)

You can use it as a single layer (flat) flower applique as well :)

The different colors of layers on this pic give you better idea on where both layers should join - they should be done in the same center ring.

The second layer:

the arcs:
DC in the same center of the flower where you made SCs for the arcs of the first layer. Each DC of the arcs of the 2nd layer is between the SCs of the arcs of the 1st layer.(just check again the previous picture).


CH 3

Make 5 more arcs [DC, CH 3] . Total number of arcs in the second layer is the same as in the first layer, 6 arcs.

Slip stitch to join the last CH 3 with the first DC.

Petals for the second layer: [SC, DC,DC,DC,DC,SC]. Repeat [ ] for each arc of the second layer.

Each petal of the second layer should be under the petal of the first layer.


The ready Crochet Rose Flower and what else can you do with it - just attach it to the hairclip! (You will need a hot glue gun, add 3-4 drops of hot glue to the hairclip and press the flower to it for 2-3 minutes untill the glue cools completely).


Return from Crochet Rose Pattern to Crochet Flower Patterns.


New! Comments

Have your say about what you just read! Leave me a comment in the box below.